iglidur® I180-PF | 750g | igus®

75.00 €
Tax excluded
Not Rated
paga in 3 rate con Klarna
pay in 3 with Klarna
paga en 3 plazos con Klarna
payez en 3 fois avec Klarna
prodotto presente su  Crea3D è presente su MEPA
Diameter
There are not enough products in stock


igus iglidur

3D printer filament: iglidur® |180-PF

Components made of igus® Tribo-Filament are up to 50 times more wear-resistant than standard materials for 3D printing and therefore have an extremely long service life. Due to their excellent tribological properties, they are suited for 3D printing of replacement parts, for example bearings, drive nuts, gears and other wear parts. The igus® Tribo-Filaments can be processed on 3D printers that are based on the fused-deposition-modelling method (FDM/FFF) and that allow the nozzle temperature to be set as required.

  • Versatile use: good combination of high wear resistance, strength and temperature resistance
  • Good processing ability with an enclosed printer and igus® adhesive film
  • Flexural strength: 46 / 33 MPa

Typical application areas

  • Special machine construction
  • Jig construction
  • Complex wear parts
I180-PF-0300-0750
General properties

Colour

white

Material suitable for

Beginner

Max. moisture absorption (at 23 °C/73 °F, 50% r.h.)

0.3 Wt.-%, test method DIN 53495

Max. water absorption

0.9 Wt.-%

Net weight

250 g

Coefficient of sliding friction, dynamic, against Cf53 steel

0.24

Coefficient of sliding friction, dynamic, against 304 stainless steel

0.17

pv value, max. (dry)

0.23 MPa ⋅ m/s

Flexural strength

46 / 33 MPa

Physical and thermal properties

Max. long-term application temperature

80 °C

Max. short-term application temperature

90 °C

Lower application temperature

-40 °C

Thermal expansion coefficient (at 23°C/73°F)

9 K-1 ⋅ 10-5, test method DIN 53752

Heat conductivity

0.23 W/(m ⋅ K), test method ASTM C 177

Pressure load

59 MPa

Max. recommended surface pressure (at +20 °C/68 °F)

30 MPa

Requirements

Mould-free according to DIN EN ISA 846 Procedure A

No

Processing instructions

Nozzle temperature (min.)

250 °C

Nozzle temperature (max.)

260 °C

Bed temperature (min.)

90 °C

Bed temperature (max.)

110 °C

Recommended adhesion

igus® adhesive film

Construction space

Closed installation space necessary

Component cooling

A component cooling is not necessary, with cooling switched on it is also possible to print

Write your review

No customer reviews for the moment.