iglidur® I150-PF | 750g | igus®

55.00 €
Tax excluded
Not Rated
paga in 3 rate con Klarna
pay in 3 with Klarna
paga en 3 plazos con Klarna
payez en 3 fois avec Klarna
prodotto presente su  Crea3D è presente su MEPA
Diameter
There are not enough products in stock


igus iglidur

3D printer filament: iglidur® |150-PF

Components made of igus® Tribo-Filament are up to 50 times more wear-resistant than standard materials for 3D printing and therefore have an extremely long service life. Due to their excellent tribological properties, they are suited for 3D printing of replacement parts, for example bearings, drive nuts, gears and other wear parts. The igus® Tribo-Filaments can be processed on 3D printers that are based on the fused-deposition-modelling method (FDM/FFF) and that allow the nozzle temperature to be set as required.

  • Typical application areas
  • Special machine construction
  • Jig construction
  • Complex wear parts

igus® adhesive film is required for a non-heated print bed.

  • Food compliant
  • tribo-filament that is easiest to process 
  • High abrasion resistance at low surface speeds 
  • Good mechanical coefficients 
  • Cost-effective
  • Compliant with EU Regulation 10/2011
I150-PF-0175-0750
General properties

Colour

white

Material suitable for

Beginner

Max. moisture absorption (at 23 °C/73 °F, 50% r.h.)

0.3 Wt.-%, test method DIN 53495

Max. water absorption

0.7 Wt.-%

Net weight

250 g

Flexural strength

54 MPa

Physical and thermal properties

Max. long-term application temperature

65 °C

Max. short-term application temperature

75 °C

Lower application temperature

-30 °C

Max. recommended surface pressure (at +20 °C/68 °F)

24 MPa

Requirements

Mould-free according to DIN EN ISA 846 Procedure A

No

Processing instructions

Nozzle temperature (min.)

240 °C

Nozzle temperature (max.)

250 °C

Bed temperature (min.)

20 °C

Bed temperature (max.)

60 °C

Recommended adhesion

igus® adhesive film or glue stick on glas (Adhesive film imperative with non-heated pressure bed)

Construction space

No closed installation space necessary

Component cooling

A component cooling is not necessary, with cooling switched on it is also possible to print

Write your review

No customer reviews for the moment.